Our Furnace Repair Services in Brighton

Brighton homeowners usually call because the furnace stopped heating, stopped moving air, started making a new noise, needs a check before winter, or is old enough that replacement is on the table. Our services line up with those situations so you get the right visit the first time. If your furnace is blowing cold air or turning on and off, start with no-heat repair; if it runs fine but you want it checked before the next cold snap, book a tune-up.

Ways we can help

Six Furnace Services, Matched to the Problem

Use the symptom to pick a starting point. Each service page explains what usually causes the problem, how we diagnose it, the typical repairs and what affects the price.

01

No-Heat Furnace Repair

For a furnace that won't turn on, won't stay lit, short cycles, or blows cold air. We test the igniter, flame sensor, pressure switch, inducer motor and control board, then fix the part that actually failed. Brighton homes see a spike in these calls during the first hard freeze of the season.

View service
02

Emergency Furnace Repair

For furnace problems that can't wait: a carbon monoxide alarm, a gas smell, or no heat when the house is dropping toward freezing. We explain what to do first for safety, then get the furnace diagnosed and repaired so pipes and people stay safe through a Colorado cold snap.

View service
03

Furnace Replacement & Estimates

For furnaces that are 15 to 20 years old, need a costly repair, or keep breaking down. We size the new furnace for your home and Brighton's altitude, explain how Colorado's 2026 ultra-low NOx rules affect your options, and handle the City of Brighton mechanical permit and inspection.

View service
04

Furnace Tune-Up & Safety Inspection

For a furnace that works but hasn't been checked in a year or more. We clean the burners and flame sensor, check the heat exchanger for cracks, test for carbon monoxide, verify gas pressure and venting, and replace the filter. A good fit for landlords between tenants and buyers before closing.

View service
05

Furnace Blower Motor Repair

For a furnace that lights but pushes little or no air through the vents, or a blower that hums without spinning. We test the run capacitor and motor, clean the blower wheel, and replace a failed PSC or ECM motor so warm air reaches every room again.

View service
06

Furnace Noise Repair

For banging at startup, squealing, rattling, grinding or humming that wasn't there before. Each sound points to a different part, from dirty burners causing delayed ignition to worn blower bearings or a failing inducer motor. We find the source and fix it before it becomes a breakdown.

View service

Choosing a service

How to Pick the Right Furnace Service

Most furnace problems fall into one of four situations. Matching your situation to the right service means the technician arrives prepared for that specific problem.

STEP 01

Check for safety first

If you smell gas, hear a carbon monoxide alarm or see flames outside the burner area, leave the house and call 911 or Xcel Energy. Once everyone is safe, book Emergency Furnace Repair.

Local service team at work
Need a quick answer?Talk with the local team.(720) 715-9099

Included with every service

What Every Furnace Service Includes

Whichever service you book, a few things stay the same. These are the standards behind every visit, from a flame sensor repair to a full replacement estimate.

Price before workYou get the price after diagnosis and before any work starts, so you decide whether to go ahead.
The failed part, explainedYou see the part that failed and hear why it failed, so you know the repair addresses the cause.
A carbon monoxide checkAny repair that involves combustion ends with a carbon monoxide test at the furnace and the supply registers.

Choosing a service

Which Furnace Service Do You Need?

Short answers to the questions people ask when they are deciding which furnace service to book.

Still wondering?(720) 715-9099

Start with No-Heat Furnace Repair if the furnace won't turn on, shuts off after a few minutes or blows cold air. Choose Emergency Furnace Repair when there is a gas smell, a carbon monoxide alarm, flame rollout, or no heat while the house is dropping toward freezing. If you smell gas or a CO alarm sounds, leave the house and call 911 or Xcel Energy first.

A repair fixes a part that has already failed, such as an igniter, flame sensor or blower capacitor. A tune-up is preventive: the furnace is cleaned, the flame sensor and burners are serviced, airflow and gas pressure are checked, and the heat exchanger and carbon monoxide levels are tested, ideally before the heating season starts.

Repair usually makes sense when the furnace is under about 15 years old and the failed part is common. Replacement deserves a look when the furnace is 15 to 20 years old or more, the repair is expensive, the same problems keep coming back, or a cracked heat exchanger is found. When the decision is close, ask for both prices.

Yes. The same six furnace services are available in Commerce City, Henderson and Fort Lupton. Each of those areas has its own page explaining local permits and the furnace problems we see most often there.

Your next step is waiting

Need furnace repair in Brighton?

Not sure which service fits? Call and describe what the furnace is doing, and we will point you to the right visit.

Start with the basics

Talk to Furnace Repair Pros

Call us at (720) 715-9099 with your furnace problem and your address. Tell us what you are seeing, whether that is no heat, short cycling, a blinking light or a noise you have not heard before, and we will set up a visit. You can also send the form on this page with a short description and the best time to reach you.

SERVICE REQUESTLet us map it out.

No spam or pressure. Just a helpful service conversation.

Thanks. Your request is in and the team will follow up shortly.

Need service?Call now